background image

COPYRIGHT © 2004 MERIT INDUSTRIES, INC.

ATTENTION:

OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES

Removal/Installation of Monitor -

FORCE Upright w/ Coin Door

Troubleshooting Information - Removal/Installation of Monitor -

FORCE Upright with Coin Door

Megatouch FORCE Technical Reference Manual

Monitor Removal

1. Turn off and unplug the game.

2. Unlock and open the rear door to gain access to the monitor.  See Figure 1.

3. Disconnect all harnesses from the monitor.

4. Remove the hardware fastening the touchscreen controller to the game, then disconnect the

cable from the back of the controller and disconnect the Molex connector (orange and gray
wires) running from the touchscreen controller cable to the main power harness.

5. Remove both bolts securing the rear of the monitor shelf to the cabinet. See Figure 2.

6. To remove the front bezel, remove the 2 wing nuts inside the CPU door along the bottom of the

bezel and the 3 wing nuts inside the game along the top piece.  Then disconnect the 2 speaker
connectors inside the game on either side of the marquee before lifting the bezel from the
game.

7. Remove both bolts securing the front of the monitor shelf to the cabinet (located on the under-

side of the shelf). See Figure 2.

8. Remove the ground strap attached to the monitor door.

9. Pull the monitor up and out through the front of the game.

Monitor Installation

1. Place the new monitor in the game.

2. Replace the ground strap on the monitor door.

3. Fasten the front of the monitor shelf to the cabinet with the 2 bolts (see Figure 2).

4. Replace the front bezel and the 5 wing nuts (2 inside the CPU door along the bottom of the

bezel, 3 along the top piece) fastening it to the game.  Then reconnect the 2 speaker connec-
tors inside the game.

5. Fasten the rear of the monitor shelf to the cabinet with the 2 bolts (see Figure 2).

6. Connect the touchscreen cable in the back of the controller and secure the controller in the

game with the existing hardware.  Also connect the Molex connector (orange and gray wires)
to the main power harness.

7. Reconnect all harnesses to the monitor.

8. Close and lock the rear door.

9. Plug in and turn on the game.

manuals/manuals_Support_Center_Force_20Upright_FORCE_20Upright_20with_20Coin_20Door_20Monitor_20Removal_20and_20Installation_pdf-html.html
background image

COPYRIGHT © 2004 MERIT INDUSTRIES, INC.

Troubleshooting Information - Removal/Installation of Monitor -

FORCE Upright with Coin Door

Megatouch FORCE Technical Reference Manual

FIGURE 2 - MONITOR REMOVAL

FIGURE 1 –  MONITOR ACCESS w/ REAR DOOR REMOVED

A

A

TOUCHSCREEN
CONTROLLER

HEX BOLT
(4 PLACES)